ECUHELP KT200 is possible to read/write Ford transit continental sid211 via OBD.
Ford transit SID211 full flash read and write with KT200, only full flash possible via OBD,and eeprom + flash in BDM mode, if you prefer to have a spare eeprom and anything went wrong, please make a backup in boot mode, then write the file modified by OBD.
All uploaded by OBD successfully. Example: to read eeprom +flash, follow boot mode instruction bellow Simens Continental SID211 [TC1791 INT.F.]
Kit to use:
– OBD cable
– Multifunction cable
– 1 resistance of 560 Ω
The password of this ECU is found at the end of reading the file using the serial driver via the OBD plug of the vehicle.
An example of serial driver for this ECU:
→ CAR → FORD → TRANSIT FT → 2.0 TDCI 105CV CONTINENTAL SID211 *CAN
At the end of the reading, therefore, the ECUHELP KT200 software saves the password in a file called Password_adv.bin in the same folder chosen for saving the file of the car.
To read and write in boot mode the ECU, copy this file in the folder where the program is installed.
READ AND WRITE ECU using ECUHELP KT200
Connect with the multifunction cable the following pinout and the boot shown below
Use the driver: → TOOLS BOOT MODE → INFINEON TRICORE Boot → SAK TC1791