KT200 II Read Write Porsche Bosch ME7.8 boot mode

KT200 II ECU Programmer is confirmed to read and write Porsche Bosch ME7.8 boot mode.

This is the outlook of the Porsche Bosch ME7.8:

Please follow KT200 II wiring diagram of BOSCH ME7.8 [C167] – Porsche [ Gasoline ] :

Kit to use:
– Multifunction cable

Connect multifunction cable as follows.

To read and write use the following driver:
→ TOOLS BOOT MODE
→ SIEMENS-INFINEON C167
→ Bosch – Flash 29F800

Attention:
If the ECU doesn’t enter boot mode, proceed as follows:
→ Switch off the ECU and remove the grey wire.
→ Connect directly to ground the boot pin with a needle.
→ Switch on the ECU.
→ Remove the ground.
→ Launch the driver and click the read / write buttons

Conclusion:
KT200 II provides a reliable solution for reading and writing the Porsche Bosch ME7.8 in boot mode, with troubleshooting steps available to resolve boot mode entry issues effectively.