ECUHELP KT200 Plus has been successfully tested for reading, writing, and performing DTC off operations on the SID208 ECU on bench.
Step 1: Connect the ECU
Begin by connecting the SID208 ECU to the KT200 Plus using the specified wiring diagram. Ensure all connections are secure before proceeding.
Step 2: Read and Save Flash Data
Use the KT200 Plus to read the Flash data from the ECU. Once the reading process is complete, save the Flash data file to your device for safekeeping.
Step 3: Read and Save EEPROM Data
Similarly, read the EEPROM data from the ECU using the KT200 Plus. Save the EEPROM data file to ensure you have a backup of the original data.
Step 4: Load the Flash File
Next, load the Flash file that contains the most up-to-date data. Ensure that the file loads successfully into the KT200 Plus software before moving forward.
Step 5: Perform DTC Off
To disable Diagnostic Trouble Codes (DTC), navigate to the “DTC Code Management” section within the KT200 Plus software. Click on “Block” to modify the necessary DTC codes, then save the changes. The Flash file should now be successfully modified.
Step 6: Write the Modified Flash File
Finally, start the process of writing the modified Flash file back to the ECU. Wait for the writing process to complete successfully.
Conclusion:
KT200 Plus has proven to be a reliable ECU Programmer for reading, writing, and modifying the SID208 ECU on bench. With its ability to efficiently handle DTC off operations, it is a valuable asset for ECU tuning and diagnostics.