ECUHELP KT200II User feedback: read/write edc17c49 bench mode, get the message “Error SetupT” (shown as bellow).
Possible reason and solution:
needs a capacitor on can, 10uf on gpt, 2 x 10uf caps on gpt to ecu.
+ to mfc cable – to ecu pin
KT200II wiring diagram of BOSCH EDC17 C49 [ 1797 ] – Fiat, Alfa Romeo, Lancia [Diesel] :
Connect the multifunction cable as follows. (4 connection modes)
Attention: If it does not enter bench mode, add ground to pin 44:
Attention:
On some EDC17C49 FCA the CAN line is shifted. If with the previous pinout doesn’t enter in bench mode, then try again by connecting it as follows:
Attention: If it does not enter bench mode, add ground to pin 44:
ECUHELP KT200II reads and writes use the following driver:
→ BENCH MODE
→ [ brand ]
→ TC1797 – FCA
→ EDC17 C49