KT200II Read/Write Fiat ME7.6.3 Full System Mode
ECUHELP KT200II ECU Programmer is confirmed to read/write the flash and eeprom data for Fiat ME7.6.3 Full system mode. To connect to the control unit using: - Multifunction cable
ECUHELP KT200II ECU Programmer is confirmed to read/write the flash and eeprom data for Fiat ME7.6.3 Full system mode. To connect to the control unit using: - Multifunction cable
ECUHELP KT200II is confirmed to read/write Audi SIMOS PCR2.1 on Bench, Flash Write Unlock no problem, EGR Off & Checksum ok. Connect the bench box v.2 to the tool and…
ECUHELP KT200II is confirmed to Read / Write Transporter 5.1 2.0 BITDI EDC17CP20 via OBD, write 15 minutes. Image 1 demo: KT200II is reading EDC17CP20 via OBD. Image 2 demo:…
ECUHELP KT200II is confirmed to read/write VW Tiguan 2019 EDC17C74 on bench, checksum by KT200II no problem. Connect the KT200II multifunction cable as follows: To read and write use the…
ECUHELP KT200II User Feedback: BMW F30 28i N20 2.0T MEVD17.2.4 (I think its same as 17.2.9.) R/W in Bench Mode: OK (read 4m30s,write 30s) Write in OBD Mode: ok (but…
ECUHELP KT200II ECU Programmer is confirmed to read/write Toyota ECU Me7.9.52 Boot mode. Connect the KT200II multifunction cable and the resistances as shown. To read and write ECU Me7.9.52 in…
ECUHELP KT200II ECU Programmer has been successfully tested for reading and writing Audi A4 8K 2.0 TDI ECU (Bosch EDC17CP14) in bench mode. To perform this operation, please follow the…
ECUHELP KT200II is confirmed to read/write Berlingo 1.5 bluehdi 2019 ECU MD1CS003 on bench ok. Tools to Use: ECUHELP KT200II - Multifunction cable - Bench Box V.2 Connect the KT200II…
ECUHELP KT200II User feedback: read/write edc17c49 bench mode, get the message “Error SetupT” (shown as bellow). Possible reason and solution: needs a capacitor on can, 10uf on gpt, 2 x…
ECUHELP KT 200 Plus Test Report: Vehicle: Audi Q7 3.0 TDI ECU:Edc17cp54 Read/write/ckecksum/clone on bench ok DTC OFF ok immo off ok TPROT ok Here are 3 images of using…